Acer G530 Series manual

47

4Install the hot-plug cage.

(1)Slide the cage into the chassis. The cage is locked to the chassis with an audible click.

5Connect the following cables to their corresponding connectors on the SATA RAID backplane board, mainboard and adapter:

Important: If a four-bay hot-plug SATA HDD cage is already installed in the top HDD bay, you must block the J1 jumper. Set pins 2 and 3 to short.

(1)Attach the SATA data cable to the SATA HDD connector on the backplane board (1), then connect the other end of the cable to the SATA connector on the SATA RAID card.

Note: SATA connectors on the controller are keyed. Make sure the SATA data cables are properly connected to its corresponding connectors on the SATA RAID card.