Acer S5301WB, S5201B service manual Edid Upgrade SOP, Equipment List, Setup Equipment

EDID Upgrade SOP

Equipment List

1.PC : with parallel (printer) port

2.EDID Board

3.Printer cable : 25pin male-female (connect PC to EDID board)

4.D-sub cable* : with full 15pin (connect EDID board to Projector)

5.HDMI cable*(connect EDID board to Projector)

6.DVI cable* (connect EDID board to Projector)

(*Note: Not every model’s EDID input (D-sub, DVI, HDMI) is the same. Need to check what kind of file you need before download.)

Setup Equipment

1.Let projector be in Full-power standby mode (Press “Power” and “Source” and plug in power cord into Projector immediately.)

2.Connect between PC, EDID board and the Projector:

“25pin male-female cable” (normal printer cable)

EDID board

PC with parallel

(printer) port

Link to Projector : For

DVI-D DDC download

(no need in X1130/ X1230/ X1230S/ X1235/ X1230K series)

Link to Projector : For HDMI DDC download (no need in

X1130/ X1230/ X1230S/ X1235/ X1230K series)

Please ignore this connector

Link to Main board :

For D-sub DDC download

3.Need to set Jumper before using EDID board :

<Jumper setting :> J6 : 1,2 short

J8 : 1,2 short

J10 : short

36