ATM Service Type | ADS Technologies version 5.2b1 manual

Configuration

ATM Service Type

Click on ATM Service Type in the left panel.

Figure 5.7 ATM Service Type

This panel allows you to select the ATM Service Type for the ATM interface. Presently, Unspecified Bit Rate (UBR) and Constant Bit Rate (CBR) are available. You can specify the Peak Cell Rate (PCR) in kbps. This panel also allows you to specify the period for the Operations And Maintenance (OAM) F5 (virtual channel) timer. If the period is set to zero, the OAM F5 loopback cell is not sent. If the period is set to a non-zero value, the loopback cell is transmitted to the remote peer according to the specified period. Note that the local peer will always respond to a loopback cell that is transmitted by the remote peer.

Once you have finished setting these parameters, click Apply to review the parameters you have entered and then click Finish to send settings to the NetDSL. Click Exit to return to the NetDSL Manager.

5-10NetDSL Software User’s Guide

Image 40

ADS Technologies version 5.2b1 manual ATM Service Type

Contents

Arescom NetDSL 800 Adsl Modem Version 5.2b1 User’s Guide Copyright Trademark Hardware Installation Software InstallationBefore You Begin NetDSL Manager Configuration Status FeatureTools Feature Troubleshooting Hot Features Before You BeginPackage Includes Bridge Packet Filtering Table Minimum System Requirements Information You Will Need Diagram of the NetDSL Hardware InstallationBack Panel Interfaces Diag Diagnostic Front Panel Interfaces Safety First Setup InstructionsPersonal Safety Product Handling Connecting to a Ethernet Port on a PC Connect to the Ethernet Connecting to the Non-Uplink Port on a Network Hub Connecting the DSL Interface Connect to the Adsl Interface Connecting to the USB Interface Connect to the USB Interface Connect to Power Connecting to a Power Supply About TCP/IP InstallationDetecting TCP/IP Windows 95/98 Installing TCP/IP Windows 95/98 Configuring TCP/IP Windows 95/98 Installing TCP/IP in Windows Detecting TCP/IP in Windows Configuring TCP/IP in Windows Detecting TCP/IP Windows NT Installing TCP/IP Windows NT 10Configuring TCP/IP Windows NT 11Installing the Software Drivers USB Installation Step USB Installation Step Continue USB Installation Step Page NetDSL Manager Installing the NetDSL SoftwareLaunching the NetDSL Manager Multiple Routers/Bridges Selection Window NetDSL Manager Subnet window NetDSL Manager Overview Tures NetDSL Manager NetDSL Manager 6NetDSL Software User’s Guide Configuration Outline of Configuration General Configuration General Configuration Administrative Security Bridge Packet Filter Modify Bridge Packet Filter LAN Configuration LAN Configuration NetDSL. Click Exit to return to the NetDSL Manager DSL Configuration DSL Configuration ATM PVC Properties ATM PVC Properties ATM Service Type ATM Service Type Configuration File Click Save Configuration File As Configuration 12NetDSL Software User’s Guide Status Feature Main Status Panel Event Log in Status LED Panel LED Panel Tab in Status Traffic Counter Traffic Counter Tab in Status DSL Status Table DSL Status Table Tab in Status Status Feature 6NetDSL Software User’s Guide Tools Feature Upgrade Firmware Upgrade Firmware Tab in Tools Reset Router/Bridge Reset Router Tools Feature 4NetDSL Software User’s Guide Troubleshooting Cannot Detect the Modem Cannot Upgrade the Firmware Modem and PC are Not in the Same Subnet Terminology for Configuration Parameters About Configuration ParametersExplaining IP Addresses Virtual Channel Identifier Bridge Packet Filtering Ethernet Cable Pinout 2NetDSL Software User’s Guide Limited Warranty Warranty InformationStandard Warranty Service Warranties Exclusive Limitation of Liability Before Returning a Product for Repair Warranty RegistrationReturn Instructions Return Instructions 4NetDSL Software User’s Guide Declaration of Conformity