TA 544 User
Page 36 of 68
IP netmask
This is the network mask used for this interface.
Local IP Address
This is the IP address for this PVC.
NAT
Use this menu to set up and use Network Address Translation on this interface.
NETWORK ADDRESS
PORT TRANSLATION
RIP
By enabling port translation, IP packets are modified as they pass through this interface. During transmis- sion, private addresses are translated into a single public (NAPT) IP address. Incoming packets are translated from the public to private address based on the protocol port numbers. Once enabled, you must set up NAT for use.
Use this menu to enable RIP on the WAN interface. (See RIP on page 34 for description of options.)
RFC 1483 Bridge
This is used to enable bridge mode on this PVC.
PPPoATM
This is used to enable bridge mode on this PVC.
Authentication
The authentication menu contains the required parameters for the authentication of the PPP peer and for being authenticated by the PPP peer. Authentication is applied between the TA 544 and the PPP peer as follows:
This parameter specifies how the TA 544 is to be authenticated by the PPP peer. There are four possible selections. See PPP on page 32 for de- scriptions of these selections.
This is the username that is used when being au- thenticated by the PPP peer.
This is the password or secret that is used when being authenticated by the PPP peer.
This is the username used to match the user to the Connection List profile. During an incoming call, the TA 544 will scan all active connection profiles and match the received PPP peer’s username. If the name is not found, then the default profile is used, if and only if the default profile has nothing in the Rx Username parameter. During and outgo- ing call, this username does not have to match the username reported by the PPP peer.
This is the password or secret that is used to au- thenticate the PPP peer.
TA 544 User Manual | © 2001, ADTRAN, Inc. |
