TA 544 User
Page 33 of 68
The following selections are possible:
PAP, CHAP OR The TA 544 will ask for EAP during the first PPP
EAP (DEF) LCP negotiation and allow the PPP peer to negotiate down to CHAP or PAP.
CHAP OR EAP The TA 544 will ask for EAP during the first PPP LCP negotiation and allow the PPP peer to negotiate down to CHAP but not PAP.
EAP ONLY The TA 544 will only allow EAP to be negotiated. If the PPP peer is not capable of doing EAP, then the connection will not succeed.
PAP ONLY The TA 544 will only allow PAP to be negotiated. If the PPP peer is not capable of doing PAP, then the connection will not succeed.
> Ethernet
Use the ETHERNET menu (Figure 11) to configure the Ethernet port on the TA 544.
Figure 11. Ethernet Menu
IP
This is used to setup the IP addresses for the LAN on the TA 544.
IP Address
The IP address assigned to the TA 544's Ethernet port is set here. This address must be unique within the network.
Subnet Mask
This is the IP network mask that is to be applied to the TA 544's Ethernet port.
Default Gateway
The default gateway is used by the TA 544 to send IP packets whose destination address is not found in the route table.
© 2001, ADTRAN, Inc. | TA 544 User Manual |
