Configuring Voice Support Config, Call Control | ADTRAN TA 544

TA 544 User Manual/61200704L1-1A

Page 43 of 68

Configuring Voice Support – Config

Use the VOICE/CONFIG menu to view and set the parameters shown in Figure 15.

Figure 15. Voice/Config Menu

> Call Control

The CALL CONTROL setting is used to configure the correct Voice Gateway protocol for voice signaling control be- tween the TA 544 and the configured Gateway. The CALL CONTROL setting must be configured correctly before the voice circuits will work correctly. The TA 544 supports Jetstream, Tollbridge, and CopperCom Voice Gateways.

> VPI

The VPI setting is used to configure the TA 544 virtual path setting used to communicate with the configured Voice Gateway.

> VCI

The VCI setting is used to configure the TA 544 virtual circuit setting used to communicate with the configured Voice Gateway.

© 2001, ADTRAN, Inc.

TA 544 User Manual

Image 43

ADTRAN TA 544 user manual Configuring Voice Support Config, Call Control

Contents

1200704L1 4200704L3 To the Holder of the Manual Trademarks Safety Instructions Limited Product Warranty USA International Contact Information 2001, ADTRAN, Inc Repair and Return Customer Service, Product Support Information, and TrainingPresales Inquiries and Applications Support Post-Sale Support Training 800 615-1176, ext Training Contents 2001, ADTRAN, Inc Figures 2001, ADTRAN, Inc Terminal Menu Firmware Updates Voice Over DSL Application Mount the Unit Unpack and Inspect the Unit System Info Firmware Revision Bootcode RevisionPart Number Serial Number Telnet Access System ConfigOperating Mode Network Timing Mode Snmp Menu Instructions for Changing Passwords Step Action Password ProtectMaint Port Menu Network Time System Utility Upgrade Firmware Config Transfer Ping Layer One Interface Configuring WAN SettingsATM Config Dslam Type Data Scrambling ATM Stats AP Receive Cells Discarded AP Receive Cell ErrorsAP Rx Cells AP Rx OAM Cells DSL Rate Config Global Configuring the Router Configuration Use this menu to enter static routes to other networks Bridge Security Ethernet Menu Ethernet MAC Address WAN This is the network mask used for this interface Use this menu to configure IP settings When set to Y ES, only IP RIP updates are sent All incoming packets from the WAN are not Bridge Table Configuring the Router StatusSession ARP cache Configuring the Router Logs Clear Network LogWrap View Call Control Configuring Voice Support Config Voice Stats Configuring Voice Support StatusGateway Stats PVC Stats Modules Table Managing the Modules Modules Configuration Managing the Modules V.35 SetupMode Following settings are used for FRF5 Following settings are used for FRF8 Isdn Interfaces Appendix A. Specifications and FeaturesNetwork Interface ATM Support Serial Data Security FeaturesPower Management Options Updating Firmware via a Forced Download Appendix B. Updating TA 544 Firmware using XmodemPress Enter until a menu appears Updating Firmware via the Console Menus 2001, ADTRAN, Inc Appendix C. Updating TA 544 Firmware using Tftp Message Meaning Message Meaning Status Bar Ode Avigation H elp Enu Path Left Pane Right Window Pane Notation Window Pane Navigation Navigating Using the Keyboard Keys Additional Terminal Menu Window Features Session Management Keystrokes Getting Help Application Diagram Voice Turn Up Step Action Appendix F. RFC1483 Quick Start IP Routing WAN Options Appendix G. RFC1483 Quick Start IP Routing with NAT Bridging Step Action Appendix H. RFC1483 Quick Start Bridging Appendix I. PPPoA Quick Start Guide