AEG 1000 67

Fig. 24: Pull out the battery pack

Note:

i Verify that the replacement batteries have the same rating as the batteries being replaced.

9.Slide the new battery package into the UPS unit. Push the battery package in firmly.

10.Replace the battery cover plate onto the screw mounts, threading the battery connector through the access slot.

11.Now connect the internal battery system by connecting the

	two battery connectors (each consisting of a red and a black	EN
	connector) with each other: red in red, black in black.	EN
	connector) with each other: red in red, black in black.
	Make sure to press the connectors quickly and
	firmly into one another (red in red, black in black).
	firmly into one another (red in red, black in black).
	If you see a small electric arc while doing this, this
	is no cause for concern.
	If the EBM cable isn´t connected to an EBM, clip the EBM
	cable back into its holder on the battery cover plate. See
	Figure 23.

12.Finally close the front panel again slowly and carefully following the directions in reversed order. Make sure that you do not pinch any wires. As the last step, don’t forget to lock the front panel into place using the two screws located in the middle. Then push the UPS completely back into the rack and fasten the UPS on the side using the four M6x16 screws that come with it.