Anapurna L/XL | AGFA Printer instruction

:ANAPURNA L/XL

OPERATOR MANUAL

Version 1.0

AB]

Image 1

AGFA Printer manual Anapurna L/XL

Contents

Anapurna L/XL Table of Contents Safety Instructions System Dimensions Printer Overview and Features Front view, parts & locations Rear view, parts & locations Cover Open Sensor Head Carriage view, parts Signal tower Color Sequence Head technology General information Anapurna UV Curable InkColor gamut Packing Main ink tanks Ink CircuitAuto ink supply Sub Ink Tank Read out How to make changes 2-Way valves Ink supply by means of negative pressure Printing heads Encoder Test can be found in the Test menu Waste Tank Ink Refill System what can go wrong… Settings in software Curing setup and sequencesLamp Type Cure Default, Set or Both UV Curing System Uni- and Bi-directional printing By default, Full power should be used whenever possible Belt Tension control Printing Table Replacement of Conveyor belt Maintenance Daily Maintenance Nozzle check/purge Maintenance Little purge Cleaning the failing heads Engine Storage AT the END of the Week Weekly Maintenance Engine is NOW Ready for a Long Stand Still Long Stand Still Engine is NOW Ready to Print Again Roll to Roll Media SetupAuto Feed System Take-Up Motor Box Rigid Support tables Rigid Media AB298/09/2006 Head Base Height Control Automatic Head Base Height Setup Mm Gap Control Program Menu Anapurna Control ProgramDisplay Printing Progress Set Top forward and Left Margin Setup Parameter Menu Good AB358/09/2006 AB368/09/2006 Test Menu Carriage will move slowly back to the Home position To end this test, select Reset Test in the same menu, Preparing an image Printing an imagePreparing the Anapurna Carriage must be moved to the home position first Printing the image While printing, press S and Y, the print is then cancelled Cancel a printPurge function on the printing Printing on heat sensitive media Tips & TricksMedia corners lift a bit up rigid media Image size/border Wasatch Rip