Printing Table, Belt Tension control | AGFA Printer specs

:ANAPURNA L/XL

OPERATOR MANUAL

7. Printing Table.

7.1.General information

-Woven Conveyor belt

-Transport is done by a step-motor

-On the table are 2 vacuum-zones with a fixed strength. The table is evenly divided in a right (1) and a left (2) side, which can be switched on in that order.

-When printing on a banner/paper type of roll media, only the right (1) vacuum side should be used. (Even when the media width is almost the engine width)

-When printing on two rigid media, both vacuum tables must be used.

7.2.Belt Tension control

-1) if the belt is touching the left or right guide, on the underside of the table.

-2) remove the metal covers on the backside (both left and right), rotate the screw at the REAR stand to CW or CCW to control the tension.

AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]18]8/09/2006]

Image 18

AGFA Printer manual Printing Table, Belt Tension control

Contents

Anapurna L/XL Table of Contents Safety Instructions Printer Overview and Features System Dimensions Front view, parts & locations Rear view, parts & locations Cover Open Sensor Head Carriage view, parts Signal tower Head technology Color Sequence Color gamut Anapurna UV Curable InkGeneral information Packing Auto ink supply Ink CircuitMain ink tanks Sub Ink Tank Read out How to make changes 2-Way valves Printing heads Ink supply by means of negative pressure Encoder Test can be found in the Test menu Ink Refill System what can go wrong… Waste Tank Lamp Type Cure Default, Set or Both Curing setup and sequencesSettings in software UV Curing System By default, Full power should be used whenever possible Uni- and Bi-directional printing Printing Table Belt Tension control Maintenance Replacement of Conveyor belt Maintenance Daily Maintenance Nozzle check/purge Little purge Cleaning the failing heads Weekly Maintenance Engine Storage AT the END of the Week Long Stand Still Engine is NOW Ready for a Long Stand Still Engine is NOW Ready to Print Again Media Setup Roll to RollAuto Feed System Take-Up Motor Box Rigid Media Rigid Support tables AB298/09/2006 Automatic Head Base Height Setup Head Base Height Control Mm Gap Display Printing Progress Anapurna Control ProgramControl Program Menu Set Top forward and Left Margin Setup Parameter Menu Good AB358/09/2006 AB368/09/2006 Test Menu To end this test, select Reset Test in the same menu, Carriage will move slowly back to the Home position Preparing the Anapurna Printing an imagePreparing an image Carriage must be moved to the home position first Printing the image Cancel a print While printing, press S and Y, the print is then cancelledPurge function on the printing Media corners lift a bit up rigid media Tips & TricksPrinting on heat sensitive media Image size/border Wasatch Rip