Agilent Technologies 6843A, 6834B, 6814B manual Protection and Status Control Keys, Cls

Command Function

Executes the clear status (*CLS) command Execute the STATus:PRESet command Return Event Status register value Return Status Byte register value

Return STAT:OPER:EVENT? value Return STAT:OPER:COND? value Return STAT:QUES:EVENT? value Return STAT:QUES:COND? value

4 - Front Panel Operation

Protection and Status Control Keys

The Protect and Status keys control the protection functions and status registers of the ac source. Refer to Chapter 4 of the Programming guide for more information on the status registers.

Protect

Press this key to access the protection menu list.

Display	Command Function
PROT:CLEAR	Clear the status registers of all activated protection signals.
	The fault causing a signal must be corrected or removed
	before the register can be cleared.
CURR:PROT <char>	Set overcurrent protection function (ON or OFF).
VOLT:PROT <value>	Set the overvoltage protection level1
DELAY <value>	Set the time delay for activating a protection fault after
	programming the output

Shift

Status

Press this key to access the status menu list. Note that in the following list, commands ending in ? clear the registers when they are read. For this reason the registers are read only after you press Enter , not when you scroll to the command

Display

*CLS

STATUS:PRESET *ESR? <value> *STB <value> pOPER:EVEN?q<value> ØOPER:COND￿<value> QUES:EVEN? <value> QUES:COND <value>

Notes:

1Programmed in peak volts. (Other voltage parameters are programmed in rms volts) value = a numeric value

char = a character string parameter

and scroll through the command list.

and scroll through the parameter list.

38