Agilent Technologies 6834B, 6814B, 6843A manual Front Panel Operation

4 - Front Panel Operation

1

2

3

Trigger

VOLT T level

VOLT level

VOLT T level

VOLT level

0.0000.0167

VOLT T level

VOLT level

090

	Figure 4-7. Trigger Delays and Phase Synchronization
	Example	Display
ϕ	This example uses the default trigger parameters. First, access the Voltage	VOLT	120
	menu and program the immediate and triggered voltage levels, followed by	VOLT:T	150
	the voltage transient mode.	VOLT:M	STEP
	Then press Trigger Control and Enter, followed by Shift Trigger.	INIT:IMMED
	In this example, you will set a trigger delay. First, access the Voltage menu	VOLT	120
	and program the immediate and triggered voltage levels, followed by the	VOLT:T	150
	voltage transient mode.	VOLT:M	STEP
	Press Trigger Control. Then press  until you access the delay parameter.	DELAY	0
	On the Entry keypad, press . 0 1 6 7 Enter.	DELAY .0167
	Then press Trigger Control and Enter, followed by Shift Trigger.	INIT:IMMED
 This example uses the phase sync mode with no delay, but synchronized at 90.		VOLT	120
	First, access the Voltage menu and program the immediate and triggered	VOLT:T	150
	voltage levels, followed by the voltage transient mode.	VOLT:M	STEP
	Press Trigger Control. Press  until you access the delay parameter. If	DELAY	0
	necessary, set it to 0. Press  until you access the sync source command. On	SYNC:SOUR PHASE
	the Entry keypad, press ° to obtain PHASE. Press Enter.

Access the Trigger Control menu again and press  to access the sync phase reference parameter. On the Entry keypad, program a 90° phase reference by entering 9 0 Enter.

Then press Trigger Control and Enter, followed by Shift Trigger.

SYNC:PHAS 90

INIT:IMMED

48