Installing and Configuring the 82350 1
2Configure GPIB Card Parameters. When the Agilent 82350 PCI GPIB Interface dialog box appears, set the VISA interface ID, SICL interface ID, Logical unit and GPIB address values as required.
Also, verify that this is the System controller for the GPIB to which it is attached (this is the typical operating mode). (See the System Controller discussion below.) Then, click the OK button. Some guidelines to set these values follow.
Changes to certain properties of the 82350, including:
N O T E
• GPIB address
• System controller flag
• SICL interface ID
• Logical unit
will not take effect until you reboot your PC. If you choose not to reboot immediately, Connection Expert will display a warning icon
until you reboot.
Figure 1-11 Configure GPIB card parameters
82350B Installation and Configuration Guide | 25 |
