2 - General Information
18
Safety Considerations
This dc source is a Safety Class 1 instrument, which means it has a protective earth terminal. That
terminal must be connected to earth ground through a power source equipped with a ground receptacle.
Refer to the Safety Summary page at the beginning of this guide for general safety information. Before
installation or operation, check the dc source and review this guide for safety warnings and instructions.
Safety warnings for specific procedures are located at appropriate places in the guide.
Options and Accessories
Table 2-1. Options
Option Description
100 87−106 Vac, 47−63 Hz
120 104−127 Vac, 47−63 Hz
220 191−233 Vac, 47−63 Hz
230 207−253 Vac, 47−63 Hz
8ZJ Delete instrument feet option
004 Output compensation is factory set to HRemote mode for best transient response.
(Refer to chapter 3, under "Output Compensation" for more information)
AXS1 Rack mount kit for two side-by-side units of equal depth. Consists of:
Lock-link kit (p/n 5061-9694) and Flange kit (p/n 5062-3974)
1CM1 Rack mount kit for one unit (p/n 5062-3972)
521 Solid-state relays to connect and disconnect the output of the dc source (Agilent 66319B/D
only). Provides the ability to either Hot-switch or Dry-switch the solid state relays.
052 Device characterization software for displaying current and voltage measurements.
1Support rails are required when rack mounting units. Use E3663A support rails for Agilent rack cabinets. If you are
using non-Agilent rack cabinets, contact the rack manufacturer to obtain support rails for your cabinet.
Table 2-2. Accessories
Item Part Number
GPIB cables 1.0 meter (3.3 ft) Agilent 10833A
2.0 meters (6.6 ft) Agilent 10833B
4.0 meters (13.2 ft) Agilent 10833C
0.5 meters (1.6 ft) Agilent 10833D
Rack mount with slide - for two side-by-side units of different depths 5062-3996; 1494-0015
Rack mount - for two side by side units of different depths 5062-3996
Rack mount with slide - for one unit 5062-3996; 1494-0015;
5062-4022