Language Dictionary - 8
93
Table 8-1. Subsystem Commands Syntax (continued) :DVM [:DC]? Returns DVM dc voltage measurement
:ACDC? Returns DVM rms voltage measurement
:VOLTage [:DC]? Returns dc voltage
:ACDC? Returns the total rms voltage (ac+dc)
:HIGH? Returns the HIGH level of a voltage pulse
:LOW? Returns the LOW level of a voltage pulse
:MAX? Retu rns maximum voltage
:MIN? Returns minimum vol t age
OUTPut[1|2]
[:STATe] <bool> Enables/disables the dc source output
:COMPensation
:MODE <mode> Sets output compensation (HREMOTE | LR EMOTE | HLOCAL | LLOCA L)
:DFI
[:STATe] <bool> Enables/disables the DFI output
:SOURce <source> Selects event source (QUES | OPER | ESB | RQS | OFF)
:PON
:STATe <state> Set power-on state (*RST | RCL0)
:PROTection
:CLEar Reset latched protection
:DELay <n> Delay after programming/before protection
:RELay:
:MODE <mode> Specifies the output relay mode (DD, HD, DH, or HH).
:RI
:MODE <mode> Sets remote inhibit operating mode (LATC | LIVE | OFF)
SENSe
:CURRent
[:DC] :RANGe [:UPPer] <n> Selects the high current measurement range
:DETector <detector> Selects the current measurement detector (ACDC | DC)
:FUNCtion <function> Configures the measurement sensor ("VOLT" | "CURR" | "DVM")
:LEAD
:STATus? Returns the setting of the open sense detection circuit
:PROTection
:STATe <state> Enables/disables open sense lead detection
:SWEep
:OFFSet
:POINts <n> Defines the pre/post d at a cap ture in the measurement
:POINts <n> Define the number of data points in the measurement
:TINTerval <n> Sets the digitizer sample spacing
:WINDow [:TYPE] <type> Sets the measurement window function (HANN | RECT)
[SOURce:]
CURRent
[:LEVel]
[:IMMediate][:AMPLitude] <n> Sets the output current limit
:TRIGgered [:AMPLitude] <n> Sets the triggered output current limit
:PROTection
:STATe <bool> Enables/disables current limit protection
CURRent2
[:LEVel]
[:IMMediate][:AMPLitude] <n> Sets the output2 current level
:TRIGgered [:AMPLitude] <n> Sets the triggered output2 current level
DIGital
:DATA [:VALue] <n> Sets and reads the digital control port
:FUNCtion <function> Configures digital control port (RIDF | DIG | TRIG)
RESistance
[:LEVel]
[:IMMediate][:AMPLitude] <n> Sets the output resistance
:TRIGgered [:AMPLitude] <n> Sets the triggered output resistance
VOLTage
[:LEVel]
[:IMMediate][:AMPLitude] <n> Sets the output voltage level
:TRIGgered [:AMPLitude] <n> Sets the triggered output voltage level