Service Name, Assign IP Address, NAT Disable | Airlink101 AR550W3G

Service Name	This is optional. Input the service name if your ISP requires it.
	Otherwise, you can leave it blank.
Assign IP Address	This is optional. Input the IP address you wish to use.

Maximum Transmission Unit (MTU) Most ISP offers MTU value to users. The default MTU value is 0

	(auto).
NAT Disable	Check this box to disable NAT and bridge data from WAN port to
	LAN port.

Click on Save after you finished all settings.

You can continue to configure other settings for the router; after you finish, please go to Tools Reboot to reboot the router so the settings will take effect (Please wait for about 35 seconds while router is rebooting).

Wi-Fi HotSpot WAN Type: This WAN type allows you to share one Wi-Fi Hotspot account with your friends or colleagues. Just follow a few steps below to connect to a remote Wi-Fi HotSpot.

Step 1 Click “Wi-Fi HotSpot” Search” button to search any available Wi-Fi Hotspot or AP (Access Point) in your environment.

28

Image 32

Airlink101 AR550W3G user manual Service Name, Assign IP Address, NAT Disable

Contents

Wireless N 150 3G/3.75G Travel Router Copyright Table of Contents Wireless Modem Status Wireless Status Statistics Information Introduction and safety information Product Information Safety Information Package Contents System Requirements Hardware Configuration Hardware Overview Hood Assembly LED Indicators Configure the Router Use Power Adapter Use USB Cable View Available Wireless Windows 7 / Vista UsersPage Select language then click Next to continue Click on Wizard Page Page Page Page Click Finish Using Web Configuration Utility Page Wizard Page Page Page Click Finish Advanced Settings Basic Settings Network Setup LAN SetupInternet Setup LAN IP Address Dial-Up Profile CountryTelecom 3G Network Password AuthenticationAccount Primary DNS Maximum Idle Time Assign IP Address Service NameNAT Disable Page Page Dhcp Server Fixed Mapping Enable Previous / Next Wireless Transmit PowerNetwork ID Ssid Channel Wireless Mode WPS SetupWireless Client List Encryption Encryption Configuring WEP EncryptionConfiguring WPA-PSK / WPA2-PSK Encryption WPS Setup Page Config Method Config ModeConfig Status Wireless Client List WPS Status Change Password Old PasswordNew Password Reconfirm Security Settings Packet Filtering Outbound Packet Filter Allow / Deny all to pass exceptThose match the following rules Source IP Port MAC Level URL Blocking URL Blocking Association Control MAC Access ControlMAC Control Or denies wireless association from clients whose MAC Administrator Time-out Remote Administrator Host PortMiscellaneous Discard Ping from WAN side Advanced Setting System Log Click on Save after you finished all settings System Time Toolbox System Info Firmware Upgrade Backup Setting Reset to Default Reboot UPnP Setting Domain Name or IP Address for Ping Test Status System Status Wireless Status Troubleshooting Router again if you use 3G service to access Internet Appendix a Hardware Specification Technical Support