ASSEMBLY

CONTROL CABLE CONNECTION TO CONTROL STICK ASSEMBLIES

First remove the Cross-Screw from the bottom of the Control Stick Assembly. DO NOT remove the screws that fasten the two housings halves together. ASMP-FL-0001

Next while holding the housing, fully shift the Handle in the Control Stick Assembly to expose the female-threaded end of the Plunger Rod. ASMP-

FL-0002

Then while holding the Handle to expose the Plunger Rod, thread the Threaded Bead ASMP-FL- 0003 of the Cable into the end of the Plunger Rod and tighten securely. Release the Handle, allowing the Cable to pull into the Control Stick Assembly.

Once Cable is attached to Plunger Rod, slide the silver Conduit Sleeve ASMP-FL-0004into the bottom of the Control Stick Assembly and align the groove in the Conduit Sleeve with the Cross-Screw Hole.

Finally Reinstall the Cross- Screw and tighten securely.

INTERSTATER 03/09

Assembly Section 3-19

© 2009 Alamo Group Inc.

ASSEMBLY

Page 103
Image 103
Alamo 803213C, FC-FL-0001 manual Control Cable Connection to Control Stick Assemblies, FL-0002