ASSEMBLY
INTERSTATER 03/09 Assembly Section 3-7
© 2009 Alamo Group Inc.
ASSEMBLY
If it is necessar y to loosen the n ut on the p ivot pin. Re-t orque the nu t to 400 ft labs. Failure
to do so will cause the nut to loosen during use, allowing the pin to come out, thereby
causing certain machine damage.
Remove belt guard. Assemble the rod end of the tilt cylinder. Use the pin located in the ears on the end of the
housing and secure with the cotter pins. Reinstall belt guard.
Attach the air breather (Item 1) to the hydraulic
tank. ASM-FL-0015
Insert drivesh aft through the pu mp moun t weldm ent
until it slides into the crank shaft pulley coupling.
When using auxiliary hydraulic pump, place the
pump drive belt around driveshaft. Place splined
pulley weldment on the driveshaft. ASM-FL-0016
NOTE: All splines on driveshaft and pump should
have anti-seize applied.
Right Wing Right Wing