Alamo FC-FL-0001 Drive Coupling Attachment, Hydraulic TANK, Supports and Mainframe Attachment

ASSEMBLY

ASSEMBLY

DRIVE COUPLING ATTACHMENT

Assemble the front coupling to the engine crankshaft pulley using the hardware supplied with the coupling. Due to the variations in the tractor models, it may be necessary to remove some of the sheet metal to facilitate mounting of the coupling. ASM-FL-0002.

HYDRAULIC TANK, SUPPORTS AND MAINFRAME ATTACHMENT

1.Attach the left hydraulic tank support and step weldment to the tractor with (4) bolts provided in your Mount Kit. Refer to your particular Tractor Installation Drawing for part numbers and quantities. ASM-FL-0003

2.Attach the right hydraulic tank support to the tractor with (4) bolts provided in your Mount Kit. Refer to your particular Tractor Installation Drawing for part numbers and quantities. ASM-FL-0004

3.To make assembly easier, the hard plumbing assembly should be installed on the Mainframe before the Mainframe is installed. Use (2) 1/2” x 1-1/2” bolts, (2) 1/2" Flatwashers, and (2) 1/2" Locknuts. Metal tubing on assembly will need to be loosened to install bolts.

4.Position the mainframe under the tractor. Lift the front of the frame and install the top two 5/8” x 2" bolts. Install a 5/8" flatwasher and a 5/8" locknut on the bolts and tighten enough to hold the frame in place.

ASM-FL-0005

INTERSTATER 03/09 Assembly Section 3-4

© 2009 Alamo Group Inc.