
ASSEMBLY
Install idler arm assembly to bearing plate. Do not secure at this time.
3.Remove fasteners and shaft protector from end of drive shaft and retain. Lightly grease shaft. Install key and driveshaft pulley. Do not secure at this time.
4.Align all three pulleys. Use spacers and shims provided to achieve alignment, then secure idler arm assembly with cotter pin #4. Secure driveshaft pulley #1 with fasteners that were retained during previous step.
5.Install drive belt #2.
6.Attach spring. One end is inserted in idler arm spring arm hole; the other end is attached to the long outboard bearing plate capscrew.
INTERSTATER 03/09 | Assembly Section |
© 2009 Alamo Group Inc.