ASSEMBLY

ASSEMBLY

1.Properly mount rear mower to tractor and install driveline. See INSTALLATION AND DRIVELINE SECTIONS.

2.Attach PTO shield to mounting bracket. Snap- on shield is positioned so lower ears engage holes in bracket; upper ears rest on top of bracket. Bolt-on shield is secured with 3/8 NC x 3/4 HHCS (4 places).

3.Attach belt guard to cutter housing then reattach belt guard fender.

Belt Guard, FORWARD ROTATION

Three 1/2 NF x 1-1/4 HHCS and nuts.

Belt Guard, REVERSE ROTATION

One 1/2 NF x 1 HHCS (upper attaching pollinator 1/2NF x 1-1/4 HHCS two plain washers, and one nut. Plain washers are located at upper two belt guard attaching points.

UNIVERSAL SLIP JOINT (PTO SHAFT): Refer to instructions supplied with shaft.

To install the driveline separates slip joint halves, then install them onto mower gearbox input shaft and tractor PTO driveline according to illustration on PTO shaft shield. Hold halves side by side, then raise and lower the mower to determine that there is no interference between halves when in the shortest position, and that there is a specified minimum amount of overlap (see PTO SHAFT - PARTS LIST section) when in the longest position. Once it is determined that the shaft will cause no clearance problems, remove the halves, rejoin them and install the assembled PTO shaft between the tractor and the mower.

After attaching PTO shaft, slowly raise and lower mower to make sure shaft will not make any contact with “A-Frame” or mower head. If a problem exists, change mounting position or lengths of lift chains by removing or adding links.

INTERSTATER 03/09

Assembly Section 3-26

© 2009 Alamo Group Inc.

Page 110
Image 110
Alamo FC-FL-0001, 803213C manual Belt Guard, Forward Rotation