OPERATION
INTERSTATER 03/09 Operation Sec tio n 4- 3
© 2009 Alamo Group In c.
OPERATION
1. Standard Equipment and Specifications
Base Unit Specifications
16’5”,18’5”, or 20’9” Overal Cutting Wid ths
Full-Length Welded Tubular Frame With Transport Lock
19-Gallon Reservoir with 12 Micron Filtration
Tandem Piston Pumps Rated @ 48 GPM @ 3800 PSI(Dual Interstater)
Tandem Piston Pump Rated @ 24 GPM @ 3800 PSI(Right & Left Hand Interstater)
4-Spool Valve with Detent Position (Dual Wing Interstater)
2-Spool Valve with Detent Position (Right & Left Hand Interstater)
Wing Mower Specification
62”. 74”, or 88” Cutting Widths
1/2” Inboard & 5/16” Outboard Side Plates
Replaceable Skid Shoes
4-1/2” x 5/16” W a ll Cuttershaft
1-5/16” Bore Greasable, Self-Aligning Cuttershaft Bearings
53 HP Piston Motor
Belt Drive From Motor to Cuttershaft with Automatic Spr ing Tension
6” Adjustable Rear Roller
1/2” to 6” Cutting Height
Available in Fine or Coarse-Cut
Front and Rear Safety Deflectors
Automatic Cut-Off Switch
Lift Cylinde r Capable of 14” Vertical Lift
Tilt Cylinder Capable of 45 Degrees Down & 90 Degrees up
10 Gauge Unitized Cutter Housing
Rear Mower Specifications
88” or 96” Cutting Width (Depending on tractor mount kit)
10-Gauge Unitized Cutter Housing
5/16” Side Plates
CAT I or CAT II Three Point Hitch
4-1/2” x 5/16” W a ll Cuttershaft
1-5/16” Bore Greasable, Self-Aligning Cuttershaft Bearings
60 HP Gearbox
6” Adjustable Rear Roller
1/2” to 6” Cutting Height
Available in Fine or Coarse-Cut
Torque Limiter Clutch
Front and Rear Safety Deflectors
CAT 4 Driveline
Belt Drive From Gearbox To Cuttershaft with Automatic Spring Tension