Alamo T 7740 Note: Replaces / Same as Bulletin, No. 041797A1, Cleanallweldsandarea, paint, Figure

Information Bulletin 041797-1 Continued from previous Page

4.After aligning the Angles to Deck (See Figure 2) tack weld them in place. Recheck all measurements and alignments, then weld in flanges in place.

5.Cleanallweldsandarea

around welds, remove weld
slag, burnt paint and etc. Re-
paint	complete area around				24-1/16" center
flanges to prevent rust.					of hole to edge
6.	Attach	new	Hitch Post		12-1/16" center
(02971928) to welded angles as					of hole to edge
					Reference Ribs
shown in Figure 3 using hard-
ware furnished with kit. Install the
Lock nut on top of the Hitch post					14--9/16" center
and the bolt heads down coming					of hole to edge
up through the flanges, this will
give the maximum strength to the
bolts and Hitch components.				Figure 2
7.	Reinstall Head to Boom				00037200 Nut (8)
by following cutting head removal & install
instructions in the Operators Parts manual.
If you do not have this manual it is recom-
mended you obtain one before proceeding
with the reinstall of head.
Hitch Post Kit # 02972231 includes -
Part No.		Qty	Description		02971928
02971928		1	Hitch Post
					Hitch Post (1)
02972111		2	Angle
02971946		2	Angle		02971946
02892100		8	Bolt
					Flange (1)
00037200		8	Locknut	02892100
02972232		1	Instruction Sheet		02972111
				Bolt (8)
Pin Kit # 02967691 includes -
					Flange (2)
02971756		1	Pin, Chrome	Figure 3	02971946
02971746		1	Bushing		Flange (1)
02970595		1	Bolt
00015800		1	Locknut
02971904		1	Instruction Sheet
Pin Kit # 02967687 includes -
02971720		1	Pin Weldment
02971701		1	Nut, Slotted	Note: Replaces / Same as Bulletin
02971702		1	Flat Washer
165020		1	Cotter Pin	No. 041797A1

TECHNICAL INFORMATION BULLETIN

No. 041797-1

This document does not authorize the repair or replacement of parts under warranty

MACHETE

© 2005 Alamo Group Inc. 1-21