Alamo T 7740 manual New Thick Blade Bar & Larger Bolts

TECHNICAL INFORMATION BULLETIN No. 061897

Alamo Industrial ™ Technical Services Department

1502 East Walnut

Seguin, Texas 78155

830-372-2708

Models: Machete, MB21 S/N 01001 - 01071, 03507 & 02684 & MB24 S/N 01001 - 01040 & 03459

Bulletin No:

061897

Date:

Jun. 18, 1997

New Thick Blade Bar & Larger Bolts:

Early October 1996, in order to ensure an extended service life, a new blade bar was introduced which featured larger blade bar leaf bolts (from 7/8" to 1-1/4") and a thicker bottom leaf. As a result, longer mounting bolts (from 3-1/2" to 4") are required to ensure adequate thread engagement into the spindle shaft.

When ordering a replacement blade bar using the original number, the new blade bar design will automatically be sent. However, the 4 longer mounting bolts may not be included.

Therefore, when ordering a replacement blade bar, ensure that the proper length mounting bolts (P/N 02964861 which is a 4" Bolt) are also replaced. DO NOT attempt to mount the new style blade bar using the old shorter bolts. The best way is to always check the replacement bottom leaf thickness as compared to the bottom leaf that was removed. If the replacement is thicker then the new longer bolts will be needed. Another way to determine which one you have check the Leaf retaining bolt size.

Blade Leaf Bar Bolts (Torque 1-1/4" bolts to 2000 ft. lbs.)

Blade Bar Mounting Bolts (Torque to 400 ft lbs.)

Figure 1

Note: Replaces / Same as Bulletin No. 061897A

This document does not authorize the repair or replacement of parts under warranty

MACHETE

© 2005 Alamo Group Inc. 1-25