TECHNICAL INFORMATION BULLETIN No. 041503

Alamo Industrial Technical Services Department

1502 East Walnut

Seguin, Texas 78155

830-372-2708

Models:

Bulletin No:

All Hydraulic Mowers Mounted on John Deere 6215 (s/n All) , 6415

 

(s/n6415M355436),6320(s/n6320H361093), 6420(s/n6420H354700)

041503

and 6615 (s/n All) Tractors with Tier II emission compliance

 

 

 

Date:

April 15, 2003

Figure 1

Factory 5

Spoke Cast

Pulley

Factory

Shouldered

Washer

Factory

Pulley

Retaining Bolt

Replacement

Pulley Part #02979857

Replacement

Washer Part

#02979829

Figure 2

In an effort to comply with certain requirements in regard to Tier II Emission Standards, Deere and Company initiated a change to the crank shaft pulley on many of the new 6020 series tractors. This was a random change, which did not affect all tractors. In addition, a specific serial number break does not exist to identify the affected units.

The Tier II pulley can be identified as a 5 spoke design as indicated in the figure above (See Figure 1). This pulley must be changed to the tapered lock, solid cast pulley as shown to allow adaptation of the required front pump drive system used to power the Alamo Industrial products. (See Figure 2)

To change the pulley:

Remove the original pulley retaining bolt, shouldered washer and pulley. (See Figure 1) Clean nose of Crankshaft using LOCKTITE® number 7649 clean and cure primer. Place a light layer 2 mm to 3 mm (.079 - .118 in.) of LOCKTITE ® brand adhesive number 680 (TY15969) to the leading edge of the crankshaft nose.

Install the replacement pulley (P/N 02979857) If any paint inside of pulley it needs to be removed. Make certain to align the pulley with crankshaft, install pulley. (See Pulley Figure 3). Do not hammer on Vibration Damper (Pulley) it must be handled in a way that avoids impact damage. Make certain that you installed the Locktite primer and adhesive as described in previous step before you installed the pulley, this is very important.

MACHETE

Continued Next Page

 

© 2005 Alamo Group Inc.

1-46

Page 52
Image 52
Alamo T 7740 manual Factory Spoke Cast Pulley