SERVICE BULLETIN No. 952911-2
Alamo Industrial Technical Services Department
1502 East Walnut
Seguin, Texas 78155
| Models: Machete Boom Mowers | Bulletin No: | Date: |
| S/N |
| |
|
| ||
| S/N | Nov. 29, 1995 | |
| (Old # 950013) | ||
|
|
| |
|
|
|
|
Parts: | Labor: | Old Parts Disposition: |
| Termination Date: |
| ||||
100 % at Dealer Net | 0.7 hr. at Dealer registered | Scrap old Parts |
| May. 1, 1996 |
| Shop Rate |
|
|
|
|
|
|
|
|
King Post Pin Replacement: (Longer Pins)
Subject:
Replace King Post Pins with new longer pins
Service Required:
1.Measure the length of the bottom king post pin, this can be done without any disassembly.
2.If Pin measurement is
3.If measurement is 5" or less, replace the pins according to the correct replacement procedure as outlined in the operators manual and / or Service Manual.
4.Boom must be flat on the floor and boom must be supported with a Hoist. All Hydraulic pressure must be released for all cylinder. See Machete service manual for this procedure.
5.Remove the pis one at a time, do not remove both pins at the same time and do not operate boom or tractor until these jobs are finished.
Install the new pin. It may be required
to move boom to align pins. Moving boom can usually be done by using the hoist supporting the Boom
7.Do Not drive pins in with a Hammer to align pins, This will damage the com-
.ponent
Parts Required:
Part No. | Qty | Description |
02966797 | 2 | King Post Pin |
Figure 1
Warranty Compensation will be provided following proper filing of warranty claim in accordance with the Alamo Industrial Warranty Policy. Claim allowance may vary in accordance with laws governing a specific region. Any Warranty associated with this service bulletin must be within authorized dates.
MACHETE
© 2005 Alamo Group Inc. |
