Alamo T 7740 Port, Electrical connection, Note orientation of notch in plate, To Valve, Machete

Information Bulletin 120697 Continued from previous Page

Electrical connection:

Identify the plus (+) lead running to the solenoid for the tilt function. This solenoid is located across the valve from the fitting you installed. Remove approximately 2 " of the outer plastic covering from the wires coming from the solenoid. Splice one of the 18 gauge wires you provided into one of the wires. Connect the other end of that wire to a lug on the solenoid. It makes a difference which wire runs to which connector. Insulate any exposed wires with electrical tape.

Note orientation of notch in plate

To Valve

Very Important ! DO NOT use

Solenoids as handles

"C-1"	"C-2"
Port	Port

Wire connector Lugs

Door

Tilt

Dipper

Lift

Swing

Steps to take to install the tilt cylinder lock valve

Hydraulic Connections

1.Remove the tilt section hose from the "C-1" Port

2.Assemble the parts as shown above.

3.Attach the hose to the fitting on Lock valve, Test and run.

TECHNICAL INFORMATION BULLETIN

No. 120697

This document does not authorize the repair or replacement of parts under warranty

MACHETE

© 2005 Alamo Group Inc. 1-31