Alcatel-Lucent 6800, 9000, 6850 user manual Open Problem Reports and Feature Exceptions

Open Problem Reports and Feature Exceptions

PR 100607

Accessing WebView > Security > Servers using Netscape, a window may appear asking for user name selection on an OS6850 when adding a new server.

Workaround: Close the window and ignore. This window shown is not a WebView pop-up window but a Netscape Form Manager window -- perhaps triggered by the "Server Name" label in the server add windows and being treated as if it was a regular form asking for a user name.

PR 106670

On an OS9000, the ipxServTable returns the name of the IPX SAP. This is a variable length name. The SNMP standard specifies that variable length strings should be preceded by a length byte. Some SNMP applications could have problems with this.

Workaround: There is no known workaround at this time.

PR 106869

In WebView > Layer 2 > VLAN Mgmt > VLANs Add page, on an OS9000, an error message appears whenever user enters VLAN ranges to be created that include more than 63 VLANs at once.

Workaround: Break desired VLAN range to create into smaller ranges (63 or less). (Note: This configu- ration setting limit occurs all throughout WebView.)

PR 106914

In WebView System > System Mgmt > Install page, on an OS9000, the file transfer fails in a dual NIC (Network Interface Card) environment.

Workaround: Momentarily disable the network of the NIC not in use for the transfer and re-enable after the transfer.

PR 107228

In WebView Physical > Health > Port Statistics page after clearing statistics, the last port of the slot may display values other than zeroes on an OS9000.

Workaround: Please ignore non-zero values. (Any non-zero values are still being cleared when the page is served.)

PR 107283

On an OS6850, when the supplicant fails the authentication with the external authentication server and if user configured a "failed" vlan on the device classification policy, then AOS is going to locally authenti- cate the supplicant. In CLI, the "show" command will show as authenticated-L to indicate that the suppli- cant failed by the external authentication server but is locally authenticated to be authorized into the user defined vlan. WebView is not showing this information and will only see as authenticated.

Workaround: Look at which vlan the supplicant is authorized and that can tell if the supplicant learned on the user defined "failed" VLAN.

page 52 OmniSwitch 6800/6850/9000—Release 6.1.3.R01