Allied Telesis AT-9000/28SP, AT-9000/52 manual Setting Lldp Port Assignments

Chapter 18: Setting LLDP and LLDP-MED

Non Strict Med TLV Order Check— Sets the switch to accept LLDP-MED advertisements even if the TLVs are not in the standard order, as specified in ANSI/TIA-1057. This configuration is useful if the switch is connected to devices that send LLDP-MED advertisements in which the TLVs are not in the standard order. Click in the box next to this field to select the nonstrict Med TLV Order Check.

Notification Interval— Sets the notification interval. This is the minimum interval between LLDP SNMP notifications (traps). The range is 5 to 3,600 seconds.

Reinit— Sets the reinitialization delay. This is the number of seconds that must elapse after LLDP is disabled on a port before it can be reinitialized. The range is 1 to 10 seconds.

Tx Delay— Specifies the transmission delay. This is the minimum time interval between transmissions of advertisements due to changes in LLDP local information.

Total Neighbors— Indicates the number of LLDP neighbors the switch has discovered on all its ports. You cannot modify this field.

Neighbors Last Update— Indicates the time since the LLDP neighbor table was last updated. You cannot modify this field.

Setting LLDP Port Assignments

5.Click Apply.

To assign LLDP to a port, do the following:

1.Select the Discovery & Monitoring tab.

The Discovery & Monitoring tab is displayed. See Figure 68 on page 201.

2.From the Discovery & Monitoring tab, select LLDP and then select Port Configurations.

212