Indication for DVD/Video CD

No disc is inserted.

-Insert a disc.

Although a disc is inserted, “NO DISC” is displayed and the unit does not start to play or eject the disc.

-Remove the disc by following these steps. Press OPEN for at least 3 seconds.

Button operation on the unit or optional remote control is not possible.

-For some discs or playing modes, certain operations are not possible. This is not a malfunction.

Disc does not match regional code number.

-Load a disc that matches the regional code number.

Indication for CD changer

Protective circuit is activated due to high temperature.

-The indicator will disappear when the temperature returns to within operation range.

Malfunction in the CD Changer.

-Consult your Alpine dealer. Press the magazine eject button and pull out the magazine.

Check the indication. Insert the magazine again.

If the magazine cannot be pulled out, consult your Alpine dealer.

Magazine ejection not possible.

-Press the magazine eject button. If the magazine does not eject, consult your Alpine dealer.

A disc is left inside the CD Changer.

-Press the eject button to activate the eject function. When the CD Changer finishes the eject function, insert an empty CD magazine into the CD Changer to receive the disc left inside the CD Changer.

Mechanism error.

1)Press OPEN and eject the disc.

If not ejecting, consult your Alpine dealer.

2)When the error indication remains after ejecting, press OPEN again.

If the error indication still does not turn off after pressing OPEN for a few times, consult your Alpine dealer.

Scratched disc, contaminated disc/poor recording/disc incompatible with this unit.

- Press OPEN.

- Change the disc.

The DVD setup operation was attempted when a disc is inserted in the unit.

- Eject the disc before the DVD setup operation.

(DivX® mode)

A sampling rate/bit rate not supported by the unit is used. Use a sampling rate/bit rate that is supported by the unit.

No magazine is loaded into the CD Changer.

-Insert a magazine.

No indicated disc.

-Choose another disc.

Indication for iPod Mode

The iPod is not connected.

-Make sure the iPod is correctly connected. Make sure the cable is not bent excessively.

There are no songs in the iPod.

-Download songs to the iPod and connect to the IVA-W502E.

Communication error.

-Turn the ignition key off, and then set to ON again.

-Check the display by reconnecting between the iPod and the unit, using the iPod cable.

68-EN

Page 69
Image 69
Alpine IVA-W502E owner manual 68-EN, Indication for DVD/Video CD, Indication for CD changer, Indication for iPod Mode