•When OFF is selected, MX effect of each MX mode will be OFF.
•Each music source, such as radio, CD and MP3 can have its own MX setting.
•MX mode does not function when MX is ON for AM radio.
•MX CMPM is applied for MP3/WMA/AAC and iPod.
•The MX setting can be performed only when a source is currently selected.
Adjusting the Parametric Equalizer Curve (P-EQ)
You can modify the Equalizer settings to create a response curve more appealing to your personal taste.
Setting item:
1 Select L+R by touching [ 
] of
When graphic EQ is set to L+R, this setting will be turned off.
2 Touch [ 
] of
The
3 Adjust the
Adjusting the Band
Touch [ 
] or [
] of BAND to select the band to be adjusted.
BAND1 / BAND2 / BAND3 / BAND4 / BAND5
Adjusting the Frequency
Touch [ 
] or [
] of FREQ. to adjust the frequency of the selected band.
Adjustable frequency bands:
20 Hz to 20 kHz (in 1/3 octave steps)
Adjusting the Level
Touch [ 
] or [
] of LEVEL to adjust the level of selected band.
Adjustable level:
Setting the Bandwidth
Touch [ 
] or [
] of Q to select the bandwidth.
Adjustable bandwidth: 1, 1.5, 3
4 To adjust another band, repeat step 3 and adjust all bands.
•The frequencies of adjacent bands cannot be adjusted within 4 steps.
•While adjusting the Parametric EQ, you should consider the frequency response of the connected speakers.
•When the parametric EQ is adjusted, the adjustment for graphic EQ becomes ineffective.
Adjusting the Graphic Equalizer Curve (G-EQ)
You can modify the equalizer settings to create a response curve more appealing to your personal taste.
Setting item:
1 Select L+R by touching [
] of
When parametric EQ is set to L+R, this setting will be turned off.
2 Touch [ 
] of
The
3 Adjust the G-EQ to your preference.
Adjusting the Band
Touch [ 
] or [
] of BAND to select the band to be adjusted.
Adjusting the Level
Touch [ 
] or [
] of LEVEL to adjust the level of selected band.
Adjustable output level:
4 To adjust another band, repeat step 3, and then adjust all bands.
•When graphic EQ is adjusted, the adjustment for parametric EQ becomes ineffective.
Setting the Time Correction Unit (T.CORR
PARAMETER)
You can change the unit, (cm or inch) of time correction.
Touch [
] or [ 
] of T.CORR PARAMETER to select cm or Inch.
Setting item: T.CORR PARAMETER
cm 
Inch
cm: The unit of time correction is cm.
Inch: The unit of time correction is inch.
Adjusting the Time Correction (T. CORR)
Before performing the following procedures, refer to “About Time Correction” (page 50).
Setting item: T.CORR
1 Touch [ 
] of T.CORR.
The T.CORR adjustment screen appears.
2 Adjust the distance (0.0 to 336.6 cm) of a desired speaker by touching the respective [
] or [
] button.
L = (distance to farthest speaker) – (distance to other speakers)
Refer to “Time Correction Value List” on page 51.
3 Repeat step 2 to set another speaker.
By setting these values to make its sound reach the listening position at the same time as the sound of other speakers.
