SYSTEM Setup
System Setup Operation
The Parking Brake must be engaged to access the SYSTEM mode screen. Attempting to access this screen while driving will display the
The following steps 1 to 4 are common operations to each “Setting item” of SYSTEM Setup. Refer to each section for details.
1 Touch [SETUP] on the main source screen.
The SETUP selection screen is displayed.
2 Touch [SYSTEM SETUP].
The SYSTEM SETUP screen appears.
3 Touch [
] or [
] etc., of the desired item to change its setting.
Setting items:
IN INT. MUTE*1 / IN INT. ICON / REMOTE SENSOR*2 / CAMERA IN / NAV. IN / NAV. MIX*3 / AUX IN / AUX IN LEVEL*4 / AUX IN
SIGNAL*4 / AUX OUT / BLUETOOTH IN / USB ADAPTER / VISUAL KEY*5 / OPTION KEY / OPTICAL OUT / AUX+ IN / AUX+ LEVEL*6
*1 Displayed only when BLUETOOTH IN is OFF.
*2 When ON is set in “Setting the Picture Output” (page 36), the item is displayed.
*3 When ON is set in “Setting the Navigation Mode” (page 36), the item is displayed.
*4 Not displayed when OFF is set in “Setting the AUX Mode” (page 36). *5 Not displayed when OFF is set in “Setting the Navigation Mode”
(page 36).
*6 Not displayed when OFF is set in “Setting the AUX+ Mode” (page 37).
4 Touch [
] to return to the previous screen.
Touch and hold [
] for at least 2 seconds to return to the main source screen that was displayed before the setup operation was started.
•Immediately after changing the settings of System Mode (while the system is writing data automatically) do not turn the ignition key (engine key) to OFF. Otherwise, the settings may not be changed.
Setting the External Device Interrupt Mode
If an Alpine
Setting item: IN INT. MUTE
Setting contents: OFF / ON
OFF: The volume level can be adjusted in Interrupt mode.
ON: Sound will not be output. The icon that is set in “Setting the Interrupt Icon Display” is displayed.
•The auxiliary device being connected must have an Interrupt wire with a negative trigger for this function to operate automatically. Otherwise, a separate switch needs to be added to switch it manually.
Setting the Interrupt Icon Display
The unit can display the icon of an external device, such as a telephone, whenever a phone call comes in to tell you there is a phone call.
Setting item: IN INT. ICON
Setting contents: INT / TEL
INT: The INT icon appears on the display.
TEL: When the external device (telephone) sends the interrupt
signal, the telephone icon appears on the display.
Switching the function of the remote sensor
For optional remote control operation, the remote sensor of the external device (monitor, etc.) can be switched, as you prefer.
Setting item: REMOTE SENSOR
Setting contents: FRONT / REAR
FRONT: The remote sensor of this unit is effective.
REAR: The remote sensor of the external monitor connected to AUX OUT of this unit becomes effective. The remote control operates the source connected to the AUX OUT terminals.
•The touch panel rear monitor sensor has priority over the remote control sensor. If the rear monitor (connected to the Alpine rear monitor output via the Monitor control lead) is touched, the command is executed regardless of the remote control sensor switch setting. Note, however, that the remote control sensor that has been set takes priority if it has been 5 seconds since last touching the panel.
•When an optional DVD changer or DVD player is connected, and the remote control sensor is set to REAR, some soft button operations
( [ 
] STOP, etc.) cannot be performed. In this case, set the remote control sensor to FRONT.
