Installation
Caution
Do not block the unit’s fan or heat sink, thus preventing air circulation. If blocked, heat will accumulate inside the unit and may cause a fire.
Air ventilation hole
Rear of the Unit
Caution concerning the installation location
1 Before installing, make sure that the opening and closing of the display will not interfere with operation of the shift lever.
Movable Display
2 Angle of installation
Install at an angle of between horizontal and 30°. Note that installing at an angle outside of this range will result in a loss of performance and possibly damage.
0
3 Remove the mounting sleeve from the main unit (see “Removal” on page 73).
The unit can be installed in the mounting sleeve in three positions by aligning its mounting holes (A to
C)on the sides of the unit. Position A will be used in most cases. If B or C are to be used, the hole positions need to be modified.
First, determine the mounting position in the mounting sleeve, then affix the supplied seal (refer to “How to use a Seal”).
Slide the unit into the mounting sleeve and secure it.
•If B or C is used, make sure that there is a enough space depthwise before installing the unit. If the unit is forcibly pushed into the mounting sleeve, damage may occur.
Mounting Sleeve (Included)
Dashboard
this unit
Seal (Included)
Pressure Plates*1
| Face Plate*2 (Included) |
<Mounting Hole Position> | |
| Position B |
Position A | Position C |
•Depending on the position chosen, the front panel will protrude differently.
Front Panel
Dashboard
Position A
Front Panel
Dashboard
Position B
Front Panel
Dashboard
Position C
*1 If the installed mounting sleeve is loose in the dashboard, the pressure plates may be bent slightly to remedy the problem.
