Alpine KD-R810 Fad/Bal *2, *3 R6 F6, Activates the keypress tone, Deactivates the keypress tone

Category		Menu item	Selectable setting, [ Initial: Underlined ]
		Fad/Bal *2, *3	R6 – F6, [ 0 ]	: Fad (fader): Press 5/∞ to adjust the front and
		Fader/balance		rear speaker output balance.
			L6 – R6, [ 0 ]	: Bal (balance): Press 4 / ¢ to adjust
				the left and right speaker output balance.
		Loud	• Loud 1/2/3	: Boost low and high frequencies to produce a
		Loudness		well-balanced sound at a low volume level.
			• Off	: Cancels.
		Volume Adjust	Level –5 —	: Preset the volume adjustment level of each source
			Level +5,	(except FM), compared to the FM volume level.
			[ Level 0 ]	The volume level will automatically increase or
				decrease when you change the source.
				• Before making an adjustment, select the source
				you want to adjust.
				• “FIX” appears on the display if “FM” is selected as
				the source.
		Subwoofer	• LPF	: Turn the control dial to select the cutoff
	Audio			frequency to the subwoofer.
				Off: All signals are sent to the subwoofer.
				LPF 55Hz/LPF 85Hz/LPF 120Hz: Frequencies
				higher than 55 Hz/85 Hz/120 Hz are cut off.
			• Level	: Turn the control dial to adjust the subwoofer
				output level. Level 00 to Level 08 [ Level 04 ]
			• Phase	: Turn the control dial to select the subwoofer
				phase. 0 Deg (normal) or 180 Deg (reverse)
		HPF	Select the cutoff frequency to the front/rear speakers. Set this to
		High Pass Filter	match the LPF settings.
			• 62Hz/95Hz/	: Frequencies lower than 62 Hz/95 Hz/135 Hz are
			135Hz	cut off.
			• Off	: All signals are sent to the front/rear speakers.
		Beep	• On	: Activates the keypress tone.
		Keytouch tone	• Off	: Deactivates the keypress tone.
		Amplifier	• High Power	: Vol 00 – Vol 50
		Gain*4	• Low Power	: Vol 00 – Vol 30 (Select if the maximum power
				of each speaker is less than 50 W to prevent
				damaging the speakers.)
*2	If you are using a two-speaker system, set the fader level to <0>.
*3	This adjustment will not affect the subwoofer output.
*4	The volume level automatically changes to “Vol 30” if you change to <Low Power> with the volume
	level set higher than “Vol 30.”

ENGLISH

27