American Dynamics ADCC1100 manual Calling a Scratch Pad Tour

ADCC1100

Holding a Tour

A tour can be stopped and held on a single camera entry by pressing the HOLD soft key. While a tour is on hold, all keyboard control actions (pan, tilt, lens adjustment, auxiliary on/off functions) can be performed on the held camera.

Note: after the HOLD soft key is pressed, its caption changes to RUN—see Restarting a Tour on Hold below.

Restarting a Tour on Hold

To restart a held tour, press the RUN soft key. The tour will continue running from the point at which it was previously held.

Stepping through a Tour

When a tour is running, the INCREMENT / DECREMENT CAMERA keys can be used to step through the tour.

To step through a tour:

1.To step forward press the ▲ key.

2.To step backward, press the ▼ key.

Reversing a Tour

When a tour is running, the INCREMENT / DECREMENT CAMERA keys can be used to reverse the direction of a tour.

To reverse the direction of a tour:

1.Press the ▼ key once. Note, to again reverse the tour, press the ▲ key once.

Stopping a Tour

A running system or scratch-pad tour can be stopped by either pressing the HOLD soft key, or by calling a camera to view on the selected monitor.

Calling a Scratch Pad Tour

Each monitor can have a stored scratch-pad tour (a temporary tour programmed by the operator).

To call a scratch-pad tour:

1.Select the monitor for the desired scratch-pad tour (ensure that there is no tour currently running on the selected monitor).

2.Press the RUN soft key.

18