Rear View
BATTERY
ALM RST REC GND ALM MODE |
| CLK CALL | |||||
| IN |
|
|
| OUT |
|
|
|
|
|
| ||||
|
| IN OUT |
| OUT |
|
|
REMOTE MIC |
| IN | RESET | |||
|
| AUDIO |
| VIDEO |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
OPEN
Warning:
The included power cord is used for 120 V, 60 Hz.
Never connect to any outlet or power supply having a different voltage or frequency.
Note Ensure the power cord is not plugged into the outlet before connecting to any rear terminals.
AC power socket
This socket connects to the power cord. Insert the cord firmly.
Input terminals
ALM IN
Use for alarm recording. The alarm sensor is connected here.
RST IN
Use to stop alarm recording.
•When “ALARM REC DURATION” in “RECORDING SET UP” menu is set to “MAN1”, the alarm recording stops when a signal is input to this terminal. The alarm reset switch is connected here.
•When set to other than “MAN1”, it can be used to adjust the VCR’s clock.
REC IN
Use to start/stop recording or for series recording.
GND
When a lead connected to other terminals requires a ground, connect the ground lead here.
Output terminals
ALM OUT
Use to indicate an alarm recording to an external alarm.
MODE OUT
Use to indicate the VCR’s mode of operation.
•When “MODE OUT” in “REAR TERMINAL” menu is set to “CLOCK ADJ”, the clock of all connected VCR’s
can be adjusted. (
page 28)
CLK OUT
Use to control an external camera switcher.
CALL OUT
Use to indicate when a tape reaches its end during recording or if there has been a problem during recording.
Battery Box
Battery is stored here.
Note
•This VCR contains a special battery. Consult your dealer to replace it.
REMOTE jack
This feature is not available with ADV096HD model.
MIC IN jack
Input jack for a microphone rated at 600
impedance.
AUDIO IN connector
Audio input connector (RCA pin).
AUDIO OUT connector
Audio output connector (RCA pin).
VIDEO IN connector
Input connector for video signal (BNC connector). Connect cameras here.
VIDEO OUT connector
Output connector for video signal (BNC connector). Connect a monitor here.
RESET button
page 37
RS-232C terminal (D-SUB 9pin)
Input terminal to connect with a personal computer via RS- 232C cross cable.
For the rating of each connector at the rear panel of VCR, 
page 36.
Reference page
