Setting Alarm Input States

1.Select Alarms/Areas/Home/Presets/PZ from the Dome Configuration Menu.

2.Select Set Alarm States.

3.Select the appropriate input line, and then change the setting.

•Select Open if the alarm normal input state is open.

•Select Closed if the alarm normal input state is closed.

The default setting is Open.

Note: In most cases, the normal input state for a dome's input should match the contact type of the connected switch.

4.Repeat step 3 for each input requiring change. When finished, continue with step 5.

5.Select Exit to return to the Alarms/Areas/Home/Presets/PZ screen.

6.When the Alarms/Areas/Home/Presets/PZ screen appears, select Exit. The Dome Configuration Menu appears. Continue with What To Do Next on page 4–20.

Assigning the Dome’s Home Position

The home position is a preset or pattern that automatically runs after a designated period of dome inactivity. Use this option if you want a specific area to be under surveillance once an operator stops moving the dome.

To assign the home position, select Set Home Position from the

Alarms/Areas/Home/Presets/PZ screen. The following screen appears:

SET HOME POSITION

HOME POSITION

 

 

NO ACTION

 

PRESET 1-96

 

PATTERN 1-3

RETURN TIME MINS 1-60 (10)

EXIT

Tip: When a pattern is selected as the home position, the pattern runs until stopped manually by issuing a camera command, such as Tilt or Focus.

4–6

SpeedDome Ultra VII Operator's Manual