Figure 5-5represents pointing the dome precisely at 225° from North (Southwest) with a tilt of 25° below the virtual horizon. Panning to the left points the dome towards the South. Panning to the right points the dome towards the West.

Figure 5-5: Pointing the dome precisely southwest with a tilt elevation of –25°

S

SW

W

-25

Changing the Display of Direction Indicators

1.Select On-Screen Text Display from the Dome Configuration Menu.

2.Move the highlight to Direction Indicator.

3.Change the setting.

•Select On to display the direction information.

•Select Off to prevent the direction information from displaying.

The default setting is Off.

4.Select Exit. The Dome Configuration Menu appears. Continue with What To Do Next on page 5–11.

Configuring the Display of Name Information

Use the Name Configuration Menu to select which name information appears on-screen. To display this screen, select Name Configuration Menu from the On-Screen Text Display screen. The following screen appears:

NAME CONFIGURATION MENU

CAMERA NAME

 

ON/OFF

AREA NAME

ON/OFF

PRESET NAME

ON/OFF

PATTERN NAME

ON/OFF

ALARM NAME

OFF/ON

FOCUS FAR to program names

RESET PROGRAMMABLE NAMES

EXIT

You can choose to enable or disable the display of camera, area, preset, pattern, and alarm names from this screen. You can reset all programmable names to their default settings. You may also initiate name programming from this screen. See Assigning or Changing Name Information on page 5–7.

5–6

SpeedDome Ultra VII Operator's Manual