Removing or Hiding Privacy Zones

If you made an error during programming or no longer require Privacy Zones, individual zones or all Privacy Zones may be deleted. To temporarily remove the Privacy Zones, you may disable their appearance by changing the Hide All Zones setting to Yes.

To delete individual Privacy Zones, you must adjust the position of the arrows to the area of the screen where the zone is recognized by the firmware. If multiple Privacy Zones are close together or overlap, the arrows blink, indicating that the selection is not allowed. Figure 4–4illustrates Privacy Zones that are close together.

Figure 4–4: Deleting Privacy Zones – Invalid Selection

Zone 2

Zone 1

Navigate to zone

Zone 3

Arrows blink to indicate this is an invalid selection.

ZOOM to delete zone

FOCUS quits w/o changing

Three Privacy Zones are illustrated. Zones 1 and 2 are overlapping. Zone 1 and 3 are in close proximity. In this situation, the arrows blink because the target area is the same distance from all three zones.

To ensure that the correct Privacy Zone is deleted, place the arrows clearly in the zone you want to delete. Figure 4–5illustrates a valid selection.

Figure 4–5: Deleting Privacy Zone – Valid Selection

Zone 2

Zone 1

Navigate to zone

Zone 3

Arrows stop blinking indicating this is a valid selection.

ZOOM to delete zone

FOCUS quits w/o changing

By moving to the left, the arrows stop blinking when the target area enters Zone 1. Pressing Zoom allows you to delete Zone 1. If you do not want to delete the zone, press Focus.

Note: Once you delete a zone, pressing Focus saves and exits from the Delete Privacy Zones screen.

4–14

SpeedDome Ultra VII Operator's Manual