American Dynamics manual 44

From this screen you can program up to eight Privacy Zones, delete all or specific Privacy Zones, or temporarily hide all Privacy Zones. For more information see:

	Topic	Page Number
How Privacy Zones are Programmed		4–12
Programming Privacy Zones		4–13
Removing or Hiding Privacy Zones		4–14
Deleting Specific Privacy Zones		4–15
Deleting All Privacy Zones		4–15
Hiding Privacy Zones		4–15

How Privacy Zones are Programmed

Privacy Zones are established by selecting three points on the display image to create a mask. The fourth point on the Privacy Zone is automatically generated by mirroring the longest axis between the three selected points. Figure 4–2illustrates how Privacy Zones are programmed.

Figure 4–2: Privacy Zone programming example

Point 1+

Point+2

+ Point 4 mirrors the longest axis.

+

Point 3

The dome’s firmware prevents you from establishing a zone that is too small or too large (greater than 90-degrees pan or tilt from the starting point).

Figure 4–3illustrates the Privacy Zone programming screen:

Figure 4–3: Privacy Zone Programming screen

NEW PRIVACY ZONE

Navigate to corner 1(2, 3)

ZOOM to Mark Corner

FOCUS to Abandon Zone

4–12 SpeedDome Ultra VII Operator's Manual