American Power Conversion PDRPPH1000, PD60H5HK1 manual Configuring the InfraStruXure Manager

Configuring the InfraStruXure Manager

Connect the InfraStruXure PDU to the InfraStruXure Manager

1.Connect a Cat-5 network cable to the surge-protected ethernet port on the PDU user connection plate.

You can make connections from

inside the enclosure, or you can remove the user connection plate and make your connections.

Remove the plate using a Phillips

or standard screwdriver to loosen the two captive screws. Use the

knockout in the plate to route cables to and from the user

connections on the plate. If you remove the plate, make sure that

you do not disturb the existing connections.

2.Run the connected Cat-5 network cable through the knockout in the user connection plate to the Information Controller Hub.

3.Once all APC InfraStruXure-Certified equipment is installed, the network cables are connected to the Information Controller Hub, and start-up of the system is complete, configure the Information Controller.

For detailed configuration instructions, see the Information Controller Installation and Quick-Startmanual included with your Information Controller.

See also

32 60kW InfraStruXure PDU—Operation and Configuration