User's Guide
6-16 Solving Problems
Table 6-1. Troubleshooting Guide––continued
Symptom Probable Cause/Corrective Action
Selected printer settings change 99
99
9Application program is over-
before printing begins. riding your settings. Change
printer setup in your applica-
program.
Pin-fed forms do not load properly. 99
99
9Forms are not loaded properly.
Refer to Loading Paper
section for detailed procedures.
99
99
9Wrong paper path selected.
Make sure Rear (or Bottom)
paper path is selected.
99
99
9Print density fine-adjustment
is set too dark. Hold down
Print Density button and re-
adjust the print density.
99
99
9PH GAP and PFORCE param-
eters on Setup menu are not
set to Auto, or settings are
incorrect. Check settings.
99
99
9Paper is not taut between trac-
tors or around platen. Reload
paper.
User's Guide
6-16 Solving Problems
Table 6-1. Troubleshooting Guide––continued
Symptom Probable Cause/Corrective Action
Selected printer settings change 99
99
9Application program is over-
before printing begins. riding your settings. Change
printer setup in your applica-
program.
Pin-fed forms do not load properly. 99
99
9Forms are not loaded properly.
Refer to Loading Paper
section for detailed procedures.
99
99
9Wrong paper path selected.
Make sure Rear (or Bottom)
paper path is selected.
99
99
9Print density fine-adjustment
is set too dark. Hold down
Print Density button and re-
adjust the print density.
99
99
9PH GAP and PFORCE param-
eters on Setup menu are not
set to Auto, or settings are
incorrect. Check settings.
99
99
9Paper is not taut between trac-
tors or around platen. Reload
paper.