![](/images/new-backgrounds/1306409/30640975x1.webp)
NXC-VAI4 Send_Commands (Cont.)
Command | Description |
|
|
PN | Sets the value of either the minimum output voltage allowed for an output, or the minimum position |
| voltage expected for an input. Voltage settings are rounded to the nearest D/A or A/D code. Voltage |
| settings for Outputs are absolute levels and are unaffected by any software scaling functions. Negative |
| voltages are not valid for Input 3. |
| Syntax: |
| SEND_COMMAND <DEV>,'P<I/O>N<LEVEL VALUE>' |
| Variables: |
| I/O: Any input or output ('1','2','3','4','5','6','7','8') |
| LEVEL VALUE: |
| Examples: |
| SEND_COMMAND <DEV>,'P1N5.023V' |
| Sets the minimum output level for Output 1 to 5.023V. |
| SEND_COMMAND |
| Sets the minimum output level for Output 1 to |
| SEND_COMMAND <DEV>,'P7N5.023V' |
| Sets the minimum of the expected input range for Input 7 to 5.023V. |
|
|
PR | Sets the CURRENT OUTPUT <x> RAMP UP TIME and/or CURRENT OUTPUT <x> RAMP DOWN |
| TIME of the specified Output where TIME is the time to ramp the full range. It can be set to ramp both |
| down to up and up to down or just down to up or just up to down. |
| Syntax: |
| SEND_COMMAND <DEV>,'P<OUTPUT>R<TIME>[UD]' |
| Variables: |
| OUTPUT: Any Output '1', '2', '3', or '4' |
| TIME: 0 - 255 in 0.1 second increments |
| U/D: Ramp Up (U) or Down (D) |
| Examples: |
| SEND_COMMAND <DEV>,'P1R25' |
| Sets CURRENT OUTPUT 1 RAMP UP TIME" and "CURRENT OUTPUT 1 RAMP DOWN TIME" to |
| 2.5 seconds each for full range travel. |
| SEND_COMMAND <DEV>,'P2R75U' |
| Sets CURRENT OUTPUT 2 RAMP UP TIME to 7.5 seconds for full range travel, CURRENT OUTPUT |
| 2 RAMP DOWN TIME remains unchanged. |
| SEND_COMMAND <DEV>,'P2R50D' |
| Sets "CURRENT OUTPUT 2 RAMP DOWN TIME" to 5 seconds for full range travel; "CURRENT |
| OUTPUT 2 RAMP UP TIME" remains unchanged. |
|
|
PU | Sets the level to which this Output is set immediately after |
| commanded. |
| Syntax: |
| SEND_COMMAND <DEV>,'P<OUTPUT>U<LEVEL VALUE>' |
| Variables: |
| OUTPUT: Any Output ('1', '2', '3', or '4') |
| LEVEL VALUE: |
| Example: |
| SEND_COMMAND <DEV>,'P1U127' |
| Sets the power up output level for Output 1 to 127. |
|
|
32 | NetLinx Cardframe, Control Cards, and NetModules - Operation Reference Guide |