APC AP9607 Signaling. Use either one of these procedures, Reboot of the system, Below, Menu, Ups

Key Concepts continued

Configuring	To use PowerChute plus on a server connected to the Inter-
PowerChute plus face Expander, configure PowerChute plus for simple
for simple	signaling. Use either one of these procedures.
signaling	1	(Re)install PowerChute plus. When the installation
		program prompts for the UPS Type, select “Back-
		UPS” and continue with the installation, including
		a reboot of the system.
	2	Run PowerChute plus and connect to the UPS.
	3	Verify that the status line on the PowerChute plus
		screen shows “On Line.” Proceed with Step 4
		below.
		OR
	1	With PowerChute plus running, select Communi-
		cation Parameters from the Configuration
		menu.
	2	Click Simple Signalling. Click OK.
	3	Close PowerChute plus.
	4	If the UPS had previously been connected using
		smart signaling:
		a Unplug the UPS.
		b Turn off the UPS output by pressing the Off
		button for at least 5 seconds.
		c Change communication cables, using the sim-
		ple signaling cable from the interface kit. (See
		“Choosing cables: Table 1” on page 4.)
	5	Restart PowerChute plus and attach the server to
		the UPS.
	6	Verify that the status of the UPS on the
		PowerChute plus screen shows “On Line.”

Continued on next page

9