Asante Technologies Voyager II user manual PPPoE setting

3.Key in the IP address of the camera and enter "PPPoE Setting" following the route Setting ￿ Basic Setting ￿ Network￿ PPPoE.

4.Key in the xDSL "Username" and "Password" acquired from your ISP. Click Save to confirm the setting.

5.Where the ADSL modem and the camera is connected via a switch-hub, you can press “Reboot” or restart the machine manually to try PPPoE dialing when the setting of the camera has been completed.

6.To know the new IP address acquired when the PPPoE dialing has been executed successful, follow the route Setting ￿ Basic Setting ￿ Network￿Notification for the IP information. You can acquire the new IP address via SMTP, FTP, and HTTP. Refer to the “Notification Setting” page for more information.

Note: You can use the DDNS function to access the camera. Refer to the “DDNS Setting” page for more information.

PPPoE setting

￿Basic Setting > Network > PPPoE > PPPoE

Dial: You can select whether or not to dial when you boot the machine (On Boot or Off).

Username: Enter the username provided by your ISP.

Password: Enter the password.

￿Basic Setting > Network > PPPoE > PPPoE Information

IP Address: The IP address acquired when the dialing has been executed successfully.

Subnet Mask: The subnet mask information acquired when the dialing has been executed successfully.

Default Gateway: The gateway information acquired when the dialing has been executed successfully.

DNS: The ISP domain name acquired when the dialing has been executed successfully.

45