AT&T 955 Table/Desk Installation, Connect the telephone line cords to the telephone

INSTALLATION INSTALLATION

NOTE: If you are installing multiple phones in your 955 system, you must install and program one set at a time. If more than one extension is assigned the same extension number, a repeating short ring (error ring) will sound at all extensions. Reassign extension numbers, being sure that each extension has a different number from 11 to 22

2Connect the telephone line cords to the telephone.

•Four One-Line Jacks (To use this installation option, you’ll need to purchase two two-line adapters. Adapters are available at retail stores or by calling 1 800 222–3111.)

(see “Assign an Extension Number to Your Phone” in SET UP SYSTEM FEATURES).

Table/Desk Installation

1 Install one 9V battery.
•	Press in on the tabs and remove the telephone base.
•	Use a small Phillips head screwdriver to remove the screw
	and open the battery door.

	Modular
	Telephone Jacks
Two-line	Lines 3 and 4
Adapters

Modular

Telephone Jacks

Lines 1 and 2

Standard

Electrical

Outlet

•	Insert the 9V battery (included), and replace the screw to
	close the battery door.
•	Replace the telephone base.

Power Cord

NOTE: The battery retains telephone memory in the event of a power failure. If power fails and a working battery is installed, this phone will work only to dial and answer calls with the handset or headset. No other features will work until power is restored.

Telephone

Line Cords

•Two Two-Line Jacks

Modular

Telephone Jack

Lines 3 and 4

Telephone Jack L1/L2 Telephone Jack L3/L4

Modular	Standard
Telephone Jack
	Electrical
Lines 1 and 2
	Outlet

Power Cord

Telephone
Line Cords	Telephone Jack L1/L2
	Telephone Jack L3/L4

8 9