INSTALLATION
3Connect the handset cord.
Plug one end of the coiled handset cord into the jack on the left side of the phone. Plug the other end into the handset, and hang up.
4Connect the power adapter.
Use only the power adapter provided with this product. To obtain a replacement, call 1 800
Plug one end of the power adapter into the jack labeled ADAPTER on the back of the phone. Plug the other end into a standard electrical outlet not controlled by a wall switch.
NOTE: If the screen displays POWERFAIL the first time you plug in the phone, press any key to clear the screen.
5Check for dial tone.
Lift the handset and listen for a dial tone. If you cannot hear a dial tone, turn to IN CASE OF DIFFICULTY.
6Initialization.
As soon as you connect the power cord, the system runs a quick
Wall Installation
1Reverse the handset tab.
Hold down the switchhook, then pull the tab out and rotate it
180 degrees. Push the tab down into the grooves so it settles into position.
INSTALLATION
2Install one 9V battery.
•Press in on the tabs and remove the telephone base.
•Use a small Phillips head screwdriver to remove the screw and open the battery door.
•Insert the 9V battery (included), and replace the screw to close the battery door.
•Replace the telephone base.
NOTE: The battery retains telephone memory in the event of a power failure. If power fails and a working battery is installed, this phone will work only to dial and answer calls with the handset or headset. No other features will work until power is restored.
3Connect the telephone line cords to the telephone. Please refer to line cord connection instructions in Step 2 of “Table/Desk Installation” on page 9.
4Turn the base, as shown, and attach it to the bottom of the phone.
10 | 11 |
