KH1508Ai / KH1516Ai User Manual
No. | Component | Description |
|
|
|
1 | Port Selection | Press a pushbutton to give the KVM focus to the computer |
| Pushbuttons | attached to its corresponding port. |
|
| Simultaneously pressing pushbuttons 1 and 2 for 3 seconds |
|
| performs a Keyboard and Mouse Reset. |
|
| Simultaneously pressing pushbuttons 15 and 16 starts Auto |
|
| Scan Mode. |
|
|
|
2 | Port LEDs | The Port LEDs are built into the Port Selection Pushbuttons. The |
|
| left ones are the On Line LEDs; the right ones are the Selected |
|
| Port LEDs: |
|
| An ONLINE LED lights GREEN to indicate that the computer |
|
| attached to its corresponding port is up and running. A flashing |
|
| LED indicates that the Port is being used for cascading to |
|
| another switch. |
|
| A SELECTED LED lights ORANGE to indicate that the computer |
|
| attached to its corresponding port is the one that has the KVM |
|
| focus. The LED is steady under normal conditions, but flashes |
|
| when its port is accessed under Auto Scan Mode. |
|
|
|
3 | Reset Switch | Pressing this switch in performs a system reset. |
|
| Note: The switch is recessed and must be pushed with a thin |
|
| object - such as the end of a paper clip, or a ballpoint pen. |
|
|
|
4 | Laptop USB | This |
| Console Port | access and control. See Laptop USB Console Login, page 50 for |
|
| further details. |
|
|
|
5 | Firmware | During normal operation and while performing a firmware upgrade, |
| Upgrade | this switch should be in the NORMAL position. If a firmware |
| Recovery | upgrade operation does not complete successfully, this switch is |
| Switch | used to perform a firmware upgrade recovery. |
|
|
|
6 | Firmware | The Firmware Upgrade Cable that transfers the firmware upgrade |
| Upgrade Port | data from the administrator's computer to the KH1508Ai / KH1516Ai |
|
| (see page 34), plugs into this |
|
|
|
7 | Power LED | Lights to indicate that the KH1508Ai / KH1516Ai is powered up and |
|
| ready to operate. |
|
|
|
8 | Station ID LED | The KH1508Ai / KH1516Ai's Station ID is displayed here. If this is a |
|
| Single Station installation (see page 14), or the First Station on a |
|
| Daisy Chained installation (see page 18), the KH1508Ai / |
|
| KH1516Ai has a Station ID of 01. |
|
| On a Daisy Chained installation, the KH1508Ai / KH1516Ai auto- |
|
| senses its position and displays the Station ID that corresponds to its |
|
| place in the chain. (see Port ID Numbering, page 24, for details). |
|
|
|
8