KH1508Ai / KH1516Ai User Manual
Setting | Function |
|
|
RESET | If you change the position of one of the stations in the daisy chain, the |
STATION IDS | OSD settings will no longer correspond to the new situation. This |
| function directs the OSD to rescan the station positions of the entire |
| installation and updates the OSD so that the OSD station information |
| corresponds to the new physical layout. |
| Note: Only the station numbers get updated. Except for the port |
| names, all administrator settings (such as Set Accessible Ports, Set |
| Quick View Ports, etc.), for all of the computers affected by the change, |
| have to be manually redone. |
|
|
SET | Specifies the operating platform of the computer attached to each port. |
OPERATING | You must configure each port on the installation. For each port, press |
SYSTEM | the [Spacebar] to cycle through the choices (PC, Mac or Sun). Repeat |
| until all the ports have been set, then press [Esc]. The default is PC. |
| Note: If you are installing a Sun or Mac computer it may not boot when |
| you run it for the first time unless you first set the correct operating |
| system for the port it is connected to. |
|
|
SET CAT 5 | Lets you specify how long the Cat 5e/6 cable between the port and the |
LENGTH | KVM adapter cable is. Press [Spacebar] to cycle through the cable |
| length settings: |
| S: Short – for up to 25 m |
| M: Medium – for between 20 and 35 m |
| L: Long – for above 35 m |
| An S, M, or L appears next to the port to indicate the choice. |
|
|
SET | Sets the keyboard language layout for the computers attached to each |
KEYBOARD | port. Press [Spacebar] to cycle through the choices: The default is |
LANGUAGE | English (US). |
|
|
FIRMWARE | In order to upgrade the KH1508Ai / KH1516Ai and adapter cable |
UPGRADE | firmware (see Device Firmware Upgrade, page 136) you must first |
| enable Firmware Upgrade mode with this setting. |
| When you bring up this menu, the current firmware version levels |
| display. Select Y to enable Firmware Upgrade mode, or N to leave this |
| menu without enabling it. |
|
|
ADAPTER | This function allows the administrator to check the firmware version of |
UPGRADE | the KVM adapter cable. When you bring up this menu, the current |
| firmware version levels display. See FIRMWARE UPGRADE, above, |
| also. |
|
|
34