Avaya 9600 manual Phnnumofsa, PHY2PRIO, PHY2VLAN, Poeconssupport

Administering Telephone Options

Table 11: 9600 Series SIP IP Telephones Customizeable System Parameters (continued)

Parameter Name	Default	Description and Value Range
	Value
PHNNUMOFSA	" " (Null)	When ENABLE_AVAYA_ENVIRONMENT=0, this value
		sets the number of Session Appearances.
PHY1STAT	1	Ethernet line interface setting (1=auto-negotiate,
		2=10Mbps half-duplex, 3=10Mbps full-duplex,
		4=100Mbps half-duplex, 5=100Mbps full-duplex, and
		6=1000Mbps full-duplex if supported by the hardware).
PHY2PRIO	0	Layer 2 priority value for frames received on or forwarded
		to the secondary Ethernet interface. Set this parameter
		only when VLAN separation is "1" (enabled). Values are
		from 0-7 and correspond to the drop-down menu
		selection.
PHY2STAT	1	Secondary Ethernet interface setting
		(0=Secondary Ethernet interface off/disabled,
		1=auto-negotiate, 2=10Mbps half-duplex, 3=10Mbps
		full-duplex, 4=100Mbps half-duplex, 5=100Mbps
		full-duplex), and, for post-Release S1.0 use,
		6=1000Mbps full-duplex (if supported by the hardware).
PHY2VLAN	0	VLAN identifier used by frames received on or forwarded
		to the secondary Ethernet interface. Set this parameter
		only when VLAN separation is “1” (enabled). Value is 1-4
		ASCII numeric digits from “0” to “4094.” Null is not a valid
		value, nor can the value contain spaces.
POE_CONS_SUPPORT	1	Flag to activate Power over Ethernet conservation mode.
		Valid values are:

0 = the telephone does not support power conservation mode.

1 = the telephone indicates support of power conservation mode by transmission of LLDP frames with appropriate indication in Avaya/Extreme proprietary PoE Conservation Support Level TLV. The telephone supports power conservation mode, if requested by reception of an LLDP frame with Avaya/Extreme proprietary PoE Conservation Level Request.

13 of 21

86 9600 Series SIP IP Telephones Administrator Guide SIP Release 2.0