Visiting User Administration
Table 14: Impact of TLVs on System Parameter Values (continued)
System | TLV |
|
Parameter Name | Name | Impact |
|
|
|
L2Q | Proprietary 802.1 | If TLV = 1, L2Q set to "1" (On). If TLV = 2, L2Q set |
| Q Framing | to "2" (Off). If TLV = 3, L2Q set to "0" (Auto). A |
|
| check is made as to whether a reset is necessary to |
|
| obtain a new IP address due to a change in the |
|
| values of the parameters L2Q or L2QVLAN. |
|
| This TLV is ignored if: |
|
| ● the value of USE_DHCP is “0” and the value |
|
| of IPADD is not “0.0.0.0”, or |
|
| ● the current L2QVLAN value was set by an |
|
| IEEE 802.1 VLAN Name, or |
|
| ● the current L2QVLAN value was set by a TIA |
|
| LLDP MED Network Policy TLV. |
|
|
|
POE_CONS_ | Proprietary - PoE | If the value of POE_CONS_SUPPORT is “1”, |
SUPPORT | Conservation Level | POE_CONS_MODE is set to the level requested in |
| Request TLV | the TLV. |
|
|
|
Visiting User Administration
A "visiting user" is anyone who logs into a 9600 Series SIP IP Telephone that is not his or her primary phone at the user’s home location. This could mean that the visiting user can log into a telephone that is across the country from the home location or one in the office adjacent to the home office. When registered as a visiting user:
●An inactivity timer is used to trigger inactivity and thereby
●Registration Events with "Q value" of 0 result in a logout. When a new registration is sent from a visiting roaming or
Issue 2 December 2007 105